Bubble Water Bell Thumb Pot - 3D Printed PLA Watering Can 12-16oz

3D Printed Watering Bell for Gentle Plant Care

This watering bell can be used to water your plants, and when not in use, add some style to a table or desk as a decorative item. A unique way to water your houseplants. Great for a calming start to the day or unwinding from a busy week. Enjoy the sounds of simulated rainfall, while your plants enjoy low-pressure watering that does not disturb their roots or soil. Available with ribbed design.

Depending on who you ask, they may call it a watering bell, a thumb pot, or a thumb watering can. RainPot makes for a great gift for the garden or houseplant lover in your life.

Specifications

Dimensions: 5"W x 4.3"H holding 12-16 ounces of water. Perfect for tiny to medium sized plants that only need a light watering. The diameter of the thumb covering is 0.4 inches. Over 20 "rain holes" on the bottom for perfect stream, every-time.

How to Use Your Thumb Pot

Submerge the entire pot into water until full. Wrap your fingers around the neck of the pot and place your thumb over the hole on the top to plug the water in. Release your thumb and the water will drain through the holes on the bottom. Place your thumb over the hole again to stop the water flow. To avoid drips as you move between plants, be sure not to tilt the pot to the side as this can reduce the pressure in the pot and create leaks.

Care Instructions

• *CLEAN FREQUENTLY*. After use, make sure to completely dry around the outside of the Waterbell with a towel. If possible, let it rest on its side or top to allow it to dry fully. To clean, fully submerge the waterbell in warm, soapy water and go through the filling and emptying process a few times. After that, let the soap wash out and go through the drying process. It is also recommended to occasionally rinse or soak in rubbing alcohol or any bacteria cleaning substance of your choice to kill off any possible bacteria that may have formed.

Eco-Friendly 3D Printed Construction

• Our planters are 3D printed with PLA - a type of thermoplastic polymer derived from Upcycled materials like Corn, Beets, and Wheat Grass. PLA is 100% biodegradable, recyclable and compostable!
• PLA Is very strong and sturdy. Sudden bumps or falls will not harm these planters as they are designe to withstand unexpected life happenings.
• Every Water Bell is thoroughly tested upon shipment. The Water Bell you receive will have tips and tricks for how to use appropriately.